Forums Erbium Lasers General Erbium Discussion Desensitization

  • This topic is empty.
Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #2834 Reply

    Glenn van As
    Spectator

    Hi folks: my good friend Andrew sent me this question today and I dont really do alot of desenstization. Could we provide some insight for him as I dont have any good answers on this. I typically restore the sites with resin as I see under the scope that even at settings below 1 watt that the root surface is etched.

    Here is his email……….

    Thanks in advance….

    Glenn

    Hi Glenn,

    I am looking through the clinical manual to the Delight. You’ve got some nice photos in there too.

    A few questions in root desensitization:

    1. In your experience, what settings might be appropriate for root desensitization? Technique in treating in terms of distance and tip used.

    2. How long lasting in general?

    3. What do you do if root area is adjacent to metal restoration?

    Please advise.

    Andrew

    #6472 Reply

    ASI
    Spectator

    Hey, people in laser dentistry land, isn’t anyone doing desensization at all?

    I am really interested in your input.

    Andrew

    #6469 Reply

    Anonymous
    Guest
    #6473 Reply

    ASI
    Spectator

    Thanks, Ron.

    Andrew

    #6471 Reply

    drlam
    Spectator

    Hi Andrew,

    You can try using .25Watt/11% Air/0% water(Waterlase)

    Start from a distance of 6mm from the sensitive surface, lase for about 10 second. Advance 1mm and lase for another 10 seconds. Repeat until your tip is 3mm close. Finish off at 2.5mm for another 10 seconds.

    Do not advance if patient shows signs of discomfort.

    Results are amazing. I figure it is long lasting too. Not enough cases to follow up yet.

    Take care,

    Wai
    drwlam.ca

    #6470 Reply

    dkimmel
    Spectator

    Andrew , Iam doing just as Wai does. So far we are 3 mo. post op on my worst patient and no relpase. MAke sure to check occlusion.
    DAvid

    #6474 Reply

    ASI
    Spectator

    Hi Wai & David,

    Wai, welcome to the forum.

    Thanks guys for your input. The Delight I have goes as low as 10Hz and 30 mj which work out to .3 W, which is just .05 W higher than the Waterlase.

    I’ll try that on the next one.

    Thanks again.

    Andrew

Viewing 7 posts - 1 through 7 (of 7 total)
Reply To: Desensitization
Your information: